Add Photos to a Drawing from the Camera (iOS)
Objective
To link photos to a location on a drawing from the camera tool on the Procore iOS app.
Things to Consider
- Required User Permissions:
- To add photos to a drawing, 'Standard' permissions on the project's Drawings tool AND 'Read Only' or higher permissions on the project's Photos tool.
Note: Users with 'Read Only' permissions to the Photos tool can only select photos that already exist in the Photos tool, while users with 'Standard' or 'Admin' permissions can also add new photos. - To publish personal markups to the Published layer, 'Standard' or 'Admin' on the project's Drawings tool. See What is the difference between personal and published markups?
- To add photos to a drawing, 'Standard' permissions on the project's Drawings tool AND 'Read Only' or higher permissions on the project's Photos tool.
- Additional Information:
- Photos pinned to a drawing via the camera as described in this article do not show up in the 'Photos from Drawings' album. Photos added to drawings from the Drawing tool will appear in the 'Photos from Drawings' album in the Photos tool.
Steps
- Open the Procore app on your iOS mobile device.
- Tap the Camera tool.
OR
Tap the Photos tool. Tap the newicon, then select Camera.
- Tap the drawing
icon to select a location on a drawing where you want the photo pinned.
- Drop a pin by tapping the area of the drawing where you want the photo linked after you take it.
- Tap Done.
- Optional: Tap Album if you want the photo(s) saved to a different album in the Photos tool instead of the 'Unclassified' album.
- Take the photo.
- Take a photo without mark up.
- Tap the shutter to take a photo.
- Take a photo with mark up.
- Tap the mark up
icon to take the photo and immediately mark it up.
- Tap the shutter to take a photo.
- Mark up the photo.
- If you want to save both the original and marked up photo, mark the Save as New Photo option, then tap Save.
OR
If you want to only save your marked up photo, clear the Save as New Photo option, then tap Overwrite.
- Tap the mark up
- Take a photo without mark up.
- Optional: Move or remove the pin and any linked photos by tapping on the drawing
icon again from the camera tool.
Note: Moving the pin causes all photos taken with the pin in the previous location to relocate to the pin's new location on the drawing. - Tap Done.
- To take more photos but link them to a new location on the same drawing or a different drawing, exit the camera using the x icon and then open it again using the bottom camera
icon.